§ 38-215. Chemical discharges.

(a)

No discharge to public sewers may contain:

(1)

Cyanide greater than 1.0 mg/l;

(2)

Fluoride other than that contained in the public water supply;

(3)

Chlorides in concentrations greater than 250 mg/l;

(4)

Gasoline, benzene, naphtha, fuel oil, or other flammable or explosive liquid, solid or gas; or

(5)

Substances causing an excessive chemical oxygen demand, COD.

(b)

No waste or wastewater discharged to public water may contain:

(1)

Strong acid, iron pickling wastes, or concentrated plating solutions, whether neutralized or not;

(2)

Fats, wax, grease or oils, whether emulsified or not, in excess of 100 mg/l or containing substances which may solidify or become viscous at temperature between 32 and 150 degrees Fahrenheit, zero and 65 degrees centigrade;

(3)

Objectionable or toxic substances, exerting an excessive chlorine requirement, to such degree that any such material received in the composite wastewater treatment works exceeds the limits established by the approving authority for such materials; or

(4)

Obnoxious, toxic or poisonous solids, liquids, or gases in quantities sufficient to violate the provisions of section 38-214(a).

(c)

No waste, wastewater, or other substance may be discharged into public sewers which has a pH lower than five or higher than 9.5, or any other corrosive property capable of causing damage or hazard to structures, equipment, or personnel at the wastewater facilities.

(d)

All waste, wastewater, or other substance containing phenols, hydrogen sulfide, or other taste- and odor-producing substances, shall conform to concentration limits established by the approving authority. After treatment of the composite wastewater, concentration limits may not exceed the requirements established by state, federal, or other agencies with jurisdiction over discharges to receiving waters.

(Code 1968, § 20-88; Ord. No. 440, § 3, 10-21-1980)